force is a push or pull

2) Force is the capacity to do work or cause physical change

3) Force= Mass times acceleration (F = ma)

4) A force is that which changes or tends to change the state of rest or motion of a body.

Examples:

For simplicity sake, all forces (interactions) between objects can be placed into two broad categories: contact forces, and forces resulting from action-at-a-distance.

Contact Forces include: frictional forces, buoyant forces, normal forces, and air resistance forces

Action-at-a-distance forces include: gravitation, electrostatic and magnetic forces.

Measuring Force:

Force is measured using either the English System of Measurements or the International System of Units (SI).

Common Units of Force

--->>SI: Newton (N) 1 N = 0.225 lb;

One Newton (N) of force is defined as the amount of force needed to accelerate 1 kilogram (kg) of mass at a rate of 1 meter per second squared (m/s2).

1 Newton = 1 kg m/sec2 (A kilogram is the amount of weight at which 1 N of force will accelerate at a rate of 1 m/s2.)

--->>English System: Pound (LB) 1 LB = 4.448 N

In English system of measurements, a slug is the amount of mass that 1 pound of force will accelerate at 1 ft/s2, and a pound mass is the amount of mass that 1 LB of force will accelerate at 32 feet/s2.

Describing a Force:

A force is a vector quantity. A vector quantity is a quantity which has both magnitude and direction. To fully describe the force acting upon an object, you must describe both its magnitude and direction. Thus, 10 Newtons of force is not a complete description of the force acting on an object. 10 Newtons, downwards is a complete description of the force acting upon an object.

(Note: What is the difference between vector and scalar quantities? A vector has both strength and direction, a scalar quantity can be described using only 1 quantity, magnitude. Examples of scalar quantities are: time, energy and volume since they only represent magnitude and no direction.

What is the Difference between Mass and Weight?

Shown below are two types of scales commonly used in the classroom --a spring scale (left) and a simple balance beam scale on the right.

On earth the spring scale reads 100g with an unknown mass attached at the bottom. To balance the scale on the right a 100g mass was also needed.

If we were to take both scales to the moon, what would the the spring scale read? How much mass would be needed to balance the 100g mass on the balance beam? Can you explain your answer? For more details see the Mass and Weight Page.

spring scale		simple balance scale

What does applying a Force do?

Force causes acceleration.

Newton's Second Law states that: the acceleration (a) of an object is directly proportional to the force (F) applied, and inversely proportional to the object's mass (m).

That means that the more force you apply to an object, the greater the acceleration. And, the more mass the object has, the lower the acceleration.

Newton's Second Law can be written in equation form: F = ma.

For falling objects we can write F=mg where g is the acceleration due to gravity. The force of gravity is what causes free falling objects to accelerate. These objects all accelerate at the same rate of 9.8 meters/sec^2

What is Friction?

Friction is the force that opposes the relative motion or tendency to such motion of two bodies in contact. If we try to push a block of wood across a table, there are two opposing forces that act: the force associated with the push, and a force that is associated with the friction which acts in the opposite direction. As frictional forces are decreased (for example, by placing oil on the table) the object moves further and further before stopping. This demonstrates Galileo's law of inertia which states: an object in a state of motion possesses an ``inertia'' that causes it to remain in that state of motion unless an external force acts on it.

Check out this SlideShare Presentation:

Classification provides a meaningful and systematic ay of studying living organisms. It allows us to group living organisms in a systematic way according to similar characteristics of the living organisms, identify relationships between different living organisms and create an easy reference to identify living organisms. It can be classified into five groups- Kingdom Monera, Kingdom Protoctista, Kingdom Fungi, Kingdom Plantae and Kingdom Animalia. Other information abt them will be posted on the next post.
- kaixin :)

WHY??
cause for the Sungei Buloh project
you all push the work to me and Jia Hao only
Is this what you call teamwork?
You guys should help in putting in more effort in
discussing the project
But did you guys do that?
NOPE
when i ask you all to go online,
only JH reply
You all think that only 2 people can work
for a project that requires 5 people?
If only 2 people do the work
Why is'nt it call "pair work"
either than "group work"?
there is a logic on why we do group works
so that we can strengthen our teamwork

SO,
JIAYOU FOR THE
SUNGEI BULOH PROJECT ON
TUESDAY. ALL OF YOU MUST
WORK AS ONE(:


-sarah

Hey pps so how have u all been not posting recently cause SA1 IS COMING!Or should i just say it has come .Anyway.A science topic coming up bye




JH